Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- OIL PRESSURE SENSOR AND CHECK POWERTRAIN CONTROL MODULE CONNECTION
- Check for loose, damaged or corroded connections on the oil pressure sensor or on the master Powertrain Control Module.
Are there any loose or damaged connections?
Yes
- Repair the wiring connections as necessary.
No
- Go to 2.
- Check for loose, damaged or corroded connections on the oil pressure sensor or on the master Powertrain Control Module.
- WIRING CHECK BETWEEN OIL PRESSURE SENSOR AND POWERTRAIN CONTROL MODULE
- Check for a short circuit to ground in the wiring between the oil pressure sensor and PIN 55 of the connector on the engine side of the powertrain control module.
Is there a short circuit to ground in the wiring?
Yes
- Repair the wiring and connections as necessary insulation to ground.
No
- Go to 3.
- Check for a short circuit to ground in the wiring between the oil pressure sensor and PIN 55 of the connector on the engine side of the powertrain control module.
- OIL PRESSURE SENSOR OPERATION CHECK
- Disconnect the right bank oil pressure sensor from the wiring. Connect the diagnostic equipment and delete the error. Check if error P06DA is present.
Is the error present?
Yes
- Replace the oil pressure sensor.
No
- End of diagnosis.
- Disconnect the right bank oil pressure sensor from the wiring. Connect the diagnostic equipment and delete the error. Check if error P06DA is present.