Description And Operation: Description
The windshield washer plumbing consists of small diameter rubber hoses that are routed from the washer reservoir located at the left windshield corner of the engine compartment. The reservoir hose is attached to the outlet nipple of the washer pump/motor unit near the bottom of the reservoir. The windshield hose is then routed up into the engine compartment. The engine compartment hose is routed along the left side of the inner fender to the hood panel.
At the hood panel the windshield washer hose is routed through several retainers to a wye fitting on the inner hood panel reinforcement. The two windshield nozzle supply hoses are attached to the wye fitting and routed on the underside of the inner hood panel reinforcement to the two windshield washer nozzles.
Washer hose or tube is available for service only as roll stock, which must then be cut to length. The molded plastic washer hose fittings cannot be repaired. If these fittings are ineffective or damaged, they must be replaced.