Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read Body Control Module (BCM) DTCs and record on the repair order.
2. Record the Environmental Data and any DTCs.
3. With the scan tool, erase DTCs.
4. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
5. With the scan tool, read BCM DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer TESTING FOR AN INTERMITTENT CONDITION to STANDARD PROCEDURE .
CHECK THE RIGHT REAR WINDOW MOTOR FOR AN OBSTRUCTION
1. Turn the ignition off.
2. Inspect the Right Rear Window Motor, Window Track and Window Regulator for any debris or obstructions that may cause an over temperature condition/stuck motor.
  Is there any debris or obstructions found?
  
  Yes
  - Remove the debris or obstruction and check the Right Rear Window Motor for proper operation. If the Right Rear Window Motor operates correctly, test complete. If the Right Rear Window Motor does not operate, replace the Right Rear Window Motor in accordance with the Service Information. Refer to MOTOR, WINDOW REGULATOR, REMOVAL AND INSTALLATION .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the Right Rear Window Motor in accordance with the Service Information. Refer to MOTOR, WINDOW REGULATOR, REMOVAL AND INSTALLATION .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .