(Electronic Steering Lock Module (ESL) - Electrical Diagnostics)

• Diagnostic Code Index
• DTC Troubleshooting
  • B1000-01-Electronic Control Unit - General Electrical Failure
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • B1001-16-Power Supply - Circuit Voltage Below Threshold
    • Notes
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • B1001-17-Power Supply - Circuit Voltage Above Threshold
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • B100A-64-Command Ignition Status - Signal Plausibility Failure
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • B1010-09-Steering Lock Motor - Component Failures
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • B1010-71-Steering Lock Motor - Actuator Stuck
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • B1011-64-Steering Lock Motor Sensor - Signal Plausibility Failure
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • B1013-62-Hardwired Vehicle Speed Signal From BSM (Braking System Module) - Signal Compare Failure
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • B1014-86 - VEHICHLE Speed From Braking System Module (BSM) - Signal Invalid
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • B1015-23-Internal Relay Ignition Switch Signal (From Body Control Module) - Signal Stuck Low
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • B1015-67-Internal Relay Ignition Switch Signal (From Body Control Module) - Signal Incorrect After Event
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • U0001-87-C Can-Missing Message
  • U0001-88-C Can-Bus Off
  • U0426-31-MINICRYPT Error - No Signal
  • U0426-62-MINICRYPT Error - Signal Compare Failure
  • U1700-86-BCM Body Control Module-Signal Invalid
  • U1700-87-Body Control Module (BCM) - Missing Message
  • U1700-8F-Body Control Module (BCM)-Erratic
  • U1701-86-Engine Controller (ECM) - Signal Invalid
  • U1701-87-ECM (Engine Control Module)-Missing Message
  • U1703-86-IPC (Instrument Panel Cluster) - Signal Invalid
  • U1703-87-IPC Instrument Panel Cluster - Missing Message
  • U1706-86-Brake System Module (BSM) - Signal Invalid
  • U1706-87-Braking System Module (BSM) - Missing Message
  • U1930-86-Ecu Operational Mode Status Internal Signal- Signal Invalid
  • U1932-86-Operational Mode Status Signal From Body Control Module- Signal Invalid
  • U1950-83-Message BCM_Command Plausibility Error - Value Of Signal Protection Calculation Incorrect
  • U1952-83-Message Brake1 Plausibility Error - Value Of Signal Protection Calculation Incorrect
• Standard Procedures
  • Electronic Steering Lock (ESL) Pre-Diagnostic Troubleshooting Procedure
    • Notes
    • Diagnostic Test
  • Electronic Steering Lock (ESL) Verification Test
    • Notes
    • Electronic Steering Lock (ESL) Verification Test