When Monitored And Set Conditions
- Ignition on.
- No under voltage DTCs.
- No over voltage DTCs.
Set Conditions:
- Chassis Domain Control Module (CDCM) is detecting a sensor or wiring problem.
Default Actions:
- Active Damping Suspension (ADS) in full firm mode.
- "Service ADS" displayed in Electronic Vehicle Information Center (EVIC).
| Possible Causes |
|---|
| LEFT REAR DAMPER VALVE CONNECTIONS |
| LEFT REAR DAMPER VALVE (+) CIRCUIT OPEN/HIGH RESISTANCE |
| LEFT REAR DAMPER VALVE (+) CIRCUIT SHORT TO GROUND |
| LEFT REAR DAMPER VALVE ACTUATOR |
| CHASSIS DOMAIN CONTROL MODULE (CDCM) |
Always perform the PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding. Refer to STANDARD PROCEDURE .