Clutch A

DISASSEMBLY 

Fig 1: Clutch A Exploded View

Courtesy of CHRYSLER GROUP, LLC

1. Remove the oil pump from the transmission case. Refer to PUMP, TRANSMISSION OIL, REMOVAL AND INSTALLATION .

   Courtesy of CHRYSLER GROUP, LLC

   NOTE:

   Apply air pressure slowly, oil may spray when B-piston releases from the assembly.

2. With one hand above B-piston (1), carefully apply air pressure into the hole directly above the B-piston alignment tab (3) to remove B-piston (2) from the assembly.

   Courtesy of CHRYSLER GROUP, LLC

3. Remove the outer ring (1) (inside B-piston).
4. Remove the snap ring (2).
5. Remove the clutches and spacers (4).
6. Remove the hub (3).

   Courtesy of CHRYSLER GROUP, LLC

7. Position the oil pump housing assembly (4) in a suitable press.
8. Using (special tool #8285, Compressor, Spring) (1), press on the fingers of the piston retainer to remove tension on the split retaining ring (2), and remove the two halves of the retaining ring (2).
9. Remove the piston retainer and plate.

ASSEMBLY 

Courtesy of CHRYSLER GROUP, LLC

Courtesy of CHRYSLER GROUP, LLC

1. Insert the piston and the retaining ring (1) into the housing.

   Courtesy of CHRYSLER GROUP, LLC

2. Position the oil pump housing assembly (4) in a suitable arbor press.
3. Using (special tool #8285, Compressor, Spring) (1), press on the fingers of the piston retaining ring to remove tension, and install the two halves of the split retainer ring (2).

   Courtesy of CHRYSLER GROUP, LLC

4. Install the hub (3).
5. Install the clutches and spacers (4).
6. Install the snap ring (2).
7. Install the outer ring (1) (below B-piston).

   Courtesy of CHRYSLER GROUP, LLC

8. Position the B-piston alignment tab (2) above the notch and install B-piston (1) on the assembly.
9. Install the transmission oil pump. Refer to PUMP, TRANSMISSION OIL, REMOVAL AND INSTALLATION .