Fluid/Filter Service
NOTE:
The transmission oil pan and filter are an integrated assembly that cannot be serviced separately.
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE
.
- Remove the transmission oil pan drain plug (1) and allow the transmission to drain.
- Remove the 13 transmission oil pan/filter bolts (1a).NOTE:
Inspect the gasket for reuse. If the seal is cut or torn, replace the gasket.
- Remove the transmission oil pan/filter (1b) and gasket. If the transmission oil pan/filter is being removed for contamination concerns discard the transmission oil pan/filter.
- Install the NEW transmission oil pan/filter (1b) and gasket.
- Install the 13 transmission oil pan/filter bolts (1a) hand tight.
- Tighten the transmission oil pan/filter bolts to 10 N.m (89 in. lbs.) using the sequence shown in illustration.
- Check and adjust the transmission fluid level. Refer to CHECK FLUID LEVEL .
- Remove the support and lower the vehicle.


