Rear Center: Installation
To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Mopar® Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.
- Position the rear center seat belt and retractor (1a) to the rear seat back support as a unit.
- Engage the tabs of the retractor bracket with the keyed holes in the seat back support.
- Install and tighten the screw (2a) that secures the retractor to the seat back support. Tighten the screw to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
- Install the flange by inserting it into the lower anchor.
- Install the rear shelf panel. Refer to PANEL, REAR SHELF, REMOVAL AND INSTALLATION .
- Install the rear seat back into the vehicle. Refer to SEAT BACK, REAR, REMOVAL AND INSTALLATION .