LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Alfa Romeo >> 2019 >> Giulia Base, AWD >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Restraints (Service Information) >> Sensor, Impact >> Removal And Installation >> B-Pillar Sensor >> Removal

B-Pillar Sensor: Removal

WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbags, airbag curtains, knee blocker, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect the Intelligent Battery Sensor (IBS)/negative battery cable assembly from the negative battery post, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

WARNING:

To avoid serious or fatal injury, never strike or drop the side impact sensor, as it can damage the impact sensor or affect its calibration. The side impact sensor enables the system to deploy the side Supplemental Restraint System (SRS) components. If an impact sensor is accidentally dropped during service, the sensor must be scrapped and replaced with a new unit. Failure to observe this warning could result in accidental, incomplete, or improper side SRS component deployment.

GC0197668Courtesy of CHRYSLER GROUP, LLC
NOTE:

Right side shown in illustration, left side similar.

  1. Adjust the driver or passenger side front seat to its most forward position for easiest access to the B-pillar.
  2. Disconnect and isolate the negative battery cable. Wait two minutes for the system capacitor to discharge before further service.
  3. Remove the trim from the inside of the lower right or left B-pillar. Refer to PANEL, B-PILLAR TRIM, LOWER, REMOVAL AND INSTALLATIONPANEL, B-PILLAR TRIM, UPPER, REMOVAL AND INSTALLATION .
  4. Remove the nut (1) that secures the B-pillar side impact sensor (2a) to the weld stud on the lower B-pillar.
  5. Disconnect the body wire harness connector (3) from the B-pillar side impact sensor (2a).
  6. Disengage the locating and anti-rotation pin of the B-pillar side impact sensor (2a) from the clearance hole in the inner B-pillar.
  7. Remove the B-pillar side impact sensor (2a) from the weld stud on the B-pillar.