Rear Center: Removal
To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Mopar® Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.
- Remove the rear seat back from the vehicle
Refer to SEAT BACK, REAR, REMOVAL AND INSTALLATION .
- Remove the rear shelf panel. Refer to PANEL, REAR SHELF, REMOVAL AND INSTALLATION .
- Disengage the seat belt flange from the lower anchor.
- Remove the screw (1a) that secures the center rear seat belt retractor (1b) to the top of the seat back support.
- Disengage the tabs of the retractor bracket from the keyed holes in the seat back support.
- Remove the rear center seat belt and retractor from the seat back support as a unit.