Diagnostic Test

NOTE:

If the scan tool shows this DTC has a Stored history of setting then the impact/pressure sensor is to be replaced.

VERIFY ACTIVE DTC

NOTE:

Make sure the battery is fully charged.

Turn the ignition on.
With the scan tool, read ORC DTCs.
Does the scan tool display an active INTERNAL ELECTRONIC FAILURE DTC or shows a setting history in stored?

Yes

WARNING:
Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
- Replace the impact/pressure sensor in accordance with the Service Information. Refer to SENSOR, IMPACT, REMOVAL AND INSTALLATION .
- Perform the RESTRAINT SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No (Did not set a active or stored INTERNAL ELECTRONIC FAILURE)
- Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to STANDARD PROCEDURE .