Air Outlet Temperature Sensor - Lower Right: Removal
WARNING:
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbags, airbag curtains, knee blocker, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect the Intelligent Battery Sensor (IBS)/negative battery cable assembly from the negative battery post, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the instrument panel cover. Refer to COVER, INSTRUMENT PANEL, REMOVAL AND INSTALLATION
.
- Disconnect the wire harness (1b) retainer (1a) from the instrument panel carrier frame.
- Disconnect the temperature sensor wire harness connector (3).
- Using trim stick C-4755 or equivalent, remove the temperature sensor (2a), by releasing the side retainers (2b) and the position tabs (2c) from the HVAC housing (2d).
