LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Alfa Romeo >> 2019 >> Giulia Base, AWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> A/C Compressor >> Heating & Air Conditioning >> Plumbing >> Line, A/C Discharge Jumper >> Removal And Installation >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING:

Review the safety precautions and warnings in this article before performing this procedure. Failure to follow these instructions may result in serious or fatal injury.

  1. Recover the refrigerant from the refrigerant system. Refer to PLUMBING, STANDARD PROCEDURE .
  2. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  3. Remove the front fascia reinforcement. Refer to REINFORCEMENT, BUMPER, FRONT, REMOVAL AND INSTALLATION .
    GC0197761Courtesy of CHRYSLER GROUP, LLC
  4. Release the retaining clamp (1a) for the A/C discharge jumper line (1b).
  5. Remove the nut (3a) that secures the A/C discharge jumper line (1b) to the A/C condenser.
  6. Remove the nut (2a) that secures the A/C discharge jumper line (1b) to the A/C discharge line (2b).
  7. Remove the A/C discharge jumper line (1b) from the engine compartment.Remove and discard the O-ring seals. 
  8. Install plugs in, or tape over the open refrigerant line fittings, the condenser and compressor ports.
scientia non olet · About LEMON Manuals