Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
2. For future reference, with the scan tool, run and save a vehicle Scan Report and all related recorded data.
3. With the scan tool, erase all DTCs.
4. Turn the ignition off for a minimum of 10.0 seconds.
5. Turn the ignition on.
6. Using the When Monitored and Set Conditions above and recorded data, operate the vehicle in the conditions that set the DTC.
7. With the scan tool, read DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
CHECK THE OCCUPANT RESTRAINT CONTROLLER (ORC) FOR DTCS
1. With the scan tool, read ORC DTCs.
  Are there any DTCs set in the ORC?
  
  Yes
  - Perform the applicable ORC diagnostic procedure(s). Refer to DIAGNOSIS AND TESTING .
  No
  - Replace and program the Occupant Restraint Controller (ORC) in accordance with the Service Information. Refer to MODULE, OCCUPANT RESTRAINT CONTROL (ORC), REMOVAL AND INSTALLATION .