LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Alfa Romeo >> 2019 >> Giulia Base, AWD >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> Front Suspension & Wheel Alignment >> Front >> Knuckle, Steering >> Removal And Installation >> RWD >> Installation

Removal And Installation: RWD: Installation

  1. Position the knuckle into place on the vehicle.
  2. Install the upper control arm ball joint into the knuckle and install a NEW  upper control arm to knuckle pinch bolt, Do not tighten at this time. 
  3. Install the lower control arm ball joint into the knuckle and install a NEW  lower control arm to knuckle mounting nut, Do not tighten at this time. 
  4. Install the tension strut ball joint into the knuckle and install a NEW  tension strut to knuckle mounting nut, Do not tighten at this time. 
  5. Carefully install the wheel speed sensor into the knuckle and install and tighten the wheel speed sensor to knuckle mounting bolt to the proper specification. Refer to TORQUE SPECIFICATIONS .
  6. Position the active damping sensor with bracket in place and install the two active damping sensor bracket to knuckle mounting bolts and securely tighten.
  7. Install the wheel studs in the hub and bearing, Do not tighten. 
    GC0197580Courtesy of CHRYSLER GROUP, LLC
  8. Mount the special tool (special tool #2000025100, Measuring Tool, Wheel Centering) (1) on the wheel stud heads.
  9. Using an appropriate plump-bob (2a) determine and mark the stud curvature (2b) that corresponds to the wheel axle (2c).
    GC0197685Courtesy of CHRYSLER GROUP, LLC
  10. Position a suitable jack under the knuckle.
  11. Raise the knuckle up until the height 373.5 mm between the wheel center (1a) and the corresponding mark on the wheel arch (1b) is reached
  12. Tighten the upper control arm to knuckle pinch bolt to the proper specification. Refer to FRONT, TECHNICAL SPECIFICATIONS .
  13. Tighten the lower control arm to knuckle mounting nut to the proper specification. Refer to FRONT, TECHNICAL SPECIFICATIONS .
  14. Tighten the tension strut to knuckle mounting bolt to the proper specification. Refer to FRONT, TECHNICAL SPECIFICATIONS .
  15. Remove the jack from under the knuckle and remove the special tool and wheel studs from the hub and bearing.
    GC0193912Courtesy of CHRYSLER GROUP, LLC
  16. Install the outer tie rod end to the knuckle and install a NEW  outer tie rod end to knuckle mounting nut and tighten to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
    GC0195240Courtesy of CHRYSLER GROUP, LLC
  17. Position the disc brake guard (1b), and install the three disc brake guard to knuckle mounting bolts (1a) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS .
  18. Install the front brake rotor. Refer to ROTOR, BRAKE, REMOVAL AND INSTALLATION .
  19. Remove the supports and lower the vehicle.
  20. Preform a wheel alignment. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals