QUADRIFOGLIO - Carbon Ceramic: Removal

Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Remove the front fascia. Refer to FASCIA, FRONT, REMOVAL AND INSTALLATION .
Remove the front brake rotor. Refer to ROTOR, BRAKE, REMOVAL AND INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC
Remove the three disc brake guard to knuckle mounting bolts (1a) and remove the disc brake guard (1b).

Courtesy of CHRYSLER GROUP, LLC
Remove the outer tie rod end to knuckle mounting nut (1a). and separate the outer tie rod end (1b) from the knuckle.

Courtesy of CHRYSLER GROUP, LLC
Using special tool (special tool #8677, Remover, Ball Joint) (1a) separate the outer tie rod end (1b) from the knuckle.

Courtesy of CHRYSLER GROUP, LLC
Holding the tension strut stud (1a) remove and DISCARD the tension strut (1c) to knuckle mounting nuts (1b).

Courtesy of CHRYSLER GROUP, LLC
Using special tool (special tool #2032500020, Remover, Front Suspension Ball Joint), (1a) separate the tension strut joint (1b) from the knuckle.
Check that the bushing is still in the original location.

Courtesy of CHRYSLER GROUP, LLC
Remove the two upper radiator support mounting nuts (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the two lower radiator support (2) mounting bolts (1).
Carefully position the radiator forward to gain access to the tension strut mounting bolt.

Courtesy of CHRYSLER GROUP, LLC
Remove and DISCARD the tension strut to crossmember mounting bolt (1a).

Courtesy of CHRYSLER GROUP, LLC
Remove the tension strut from the vehicle.