QUADRIFOGLIO - Non Carbon Ceramic: Installation
NOTE:
Installation process is the same for both sides of the vehicle.
NOTE:
If the front brake pads need to be replaced, connect the scan tool to the Data Link Connector (DLC), select "ABS" and start the following procedures: Brake Pads
- Install the new brake pads (1a) in their seats, taking care that the pad wear indicator wiring connectors (1c) are facing up.
- Install the tensioner (1a) and tighten the mounting screw (1b) to the proper specification. Refer to TORQUE SPECIFICATIONS .
- Install the brake pad anti-rattle spring (2) with the arrow shown in illustration pointing upwards.
- Install the brake pad pins (3).
- Connect the brake pad wear sensor wire harness connector (4) and engage the electrical connection on the retaining bracket.
- Pump brake pedal several times to set pads to caliper and brake rotor.
- Check the brake fluid level in the reservoir and top off, if necessary.
- Securely tighten the brake fluid reservoir cap on the brake fluid reservoir.
- Install the tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
- Connect the negative battery cable.
- Perform the brake system bleed. Refer to STANDARD PROCEDURE .
- Remove the support and lower the vehicle.
