LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Alfa Romeo >> 2019 >> Giulia Base, AWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Base Brakes (Service Information) >> Hydraulic/Mechanical >> Pads, Brake, Rear >> Removal And Installation >> Base >> Removal

Removal And Installation: Base: Removal

NOTE:

Connect a scan tool, go to "ABS" control unit in the "miscellaneous functions" menu and go to the "Electric Park Brake (EPB)", then start the "MAINTENANCE MODE" procedure.

  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Disconnect and isolate the negative battery cable.
  3. Remove the tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
    GC0194452Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the brake pad wear sensor electrical harness connection.
    GC0193407Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the electric parking brake (EPB) actuator electrical connection (1) on the rear brake caliper.
    GC0193644Courtesy of CHRYSLER GROUP, LLC
  6. Remove the rear brake caliper retaining clip (1).
    GC0193098Courtesy of CHRYSLER GROUP, LLC
  7. Remove the protective cap from the rear brake caliper upper mounting bolt (1).
    GC0193620Courtesy of CHRYSLER GROUP, LLC
  8. Remove the upper caliper to caliper adapter bracket mounting bolt (1).
    GC0193254Courtesy of CHRYSLER GROUP, LLC
  9. Rotate the rear brake caliper on the lower pin.
    GC0194680Courtesy of CHRYSLER GROUP, LLC
  10. Remove the inner brake pad (1a), complete with spring (1b) and electrical harness (1c) of the brake pad wear sensor.
    GC0193177Courtesy of CHRYSLER GROUP, LLC
  11. Remove the outer brake pad (1).
scientia non olet · About LEMON Manuals