LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Alfa Romeo >> 2019 >> Giulia Base, AWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Base Brakes (Service Information) >> Hydraulic/Mechanical >> Pads, Brake, Rear >> Removal And Installation >> Base >> Installation

Removal And Installation: Base: Installation

NOTE:

Carefully clean the pad seat area using suitable materials and products (e.g. a moist cloth).

NOTE:

Do not use products which could damage rubber parts.

NOTE:

Check that there is no damage to the pistons or the dust boots.

NOTE:

The brake pad wear sensor must be installed on the inboard side of the rotor.

  1. Install the NEW  brake pads.
    GC0194105Courtesy of CHRYSLER GROUP, LLC
  2. Install the brake caliper, engaging the brake pads in their housings and tighten the upper caliper to caliper adapter bracket mounting bolt to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  3. Install the protective cap to the rear brake caliper upper mounting bolt.
  4. Engage the clip securing the brake caliper to the bracket.
  5. Connect the electric parking brake (EPB) actuator electrical harness connector on the rear brake caliper.
  6. Connect the brake pad wear sensor electrical connector.
  7. Install the tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
  8. Connect the negative battery cable.
  9. Pump brake pedal several times to set pads to caliper and brake rotor.
  10. Remove the supports and lower the vehicle.
  11. Connect the scan tool to the vehicle, select ABS in the "miscellaneous functions" select "electric park brake" then start the "ASSEMBLY CHECK" procedure.
  12. Perform the brake system bleed. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals