Rear QUADRIFOGLIO - Carbon Ceramic: Installation
NOTE:
When replacing the rear brake disc, connect the diagnosis instrument to the vehicle diagnosis socket, go to "ABS control unit" and start the "Brembo® information CCM service reset" procedure
NOTE:
Clean the hub face to remove any dirt or corrosion where the rotor mounts.
- Install the rear brake disc (1a) in its housing and install and tighten the Brake Rotor to Hub Bolt - Rear bolt (1b) to the proper specification. Refer to TORQUE SPECIFICATIONS
.
- Install the brake caliper (1a) complete with tube in its housing and tighten the mounting bolts (1b) to the proper specification. Refer to TORQUE SPECIFICATIONS .
- Connect the brake pad wear indicator electrical harness connector (2)
- Install the parking brake caliper. Refer to CALIPER, PARKING BRAKE, REMOVAL AND INSTALLATION .
- Install the tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
- Remove the support and lower the vehicle.
- Connect the scan tool to the Data Link Connector (DLC), go to "ABS" control unit in the "miscellaneous functions" menu, go to the "Electric Park Brake (EPB)" and perform the "ASSEMBLY CHECK" procedure.
