Electric Park Brake (EPB) Will Not Engage
When the parking brake is operated, the rear wheels are not locked.
| STEP | OPERATIONS TO BE CARRIED OUT | TEST RESULTS | ||
|---|---|---|---|---|
| CHECK USING DIAGNOSIS EQUIPMENT | EVERYTHING OK | PROBLEMS ENCOUNTERED | OPERATION | |
| 1 | Connect the diagnosis equipment and check on the Antilock Brake System (ABS)/EPB control unit in error environment mode:
in parameters mode:
|
Go to Step 2 . | 1. No dialogue with the ABS/EPB control unit. | 1. Restore the correct power supply for the ABS/EPB control unit. |
| 2. Presence of errors in the ABS/EPB control unit | 2. Proceed as instructed by the diagnosis equipment. | |||
| 2 | With diagnosis equipment connector, perform the rear brake caliper diagnosis in "Actuators" environment. | Go to Step 4 . | Actuators do not activate | Go to Step 3 . |
| 3 | Check the continuity and insulation of electrical connections between ABS/EPB control unit and rear caliper "actuators" Refer to PARKING BRAKE, DESCRIPTION AND OPERATION . |
Go to Step 4 . | Electrical connections fault | Repair the connections. Refer to PARKING BRAKE, DESCRIPTION AND OPERATION . |
| 4 | Check that static and dynamic operation of the parking brake is correct. | End of diagnosis | Fault persists | Replace the ICU. Refer to INTEGRATED CONTROL UNIT (ICU), REMOVAL AND INSTALLATION . |