Removal And Installation: Removal
NOTE:
If the parking brake caliper was replaced, connect the diagnosis equipment to the car diagnosis socket, go to ABS control unit in the "miscellaneous functions" menu, go to the "ELECTRIC HAND BRAKE MANAGEMENT" procedure and start the procedure: Reset internal Brembo® counter.
NOTE:
Connect the diagnosis equipment to the car diagnosis socket, go to ABS control unit in the "miscellaneous functions" menu and go to the "ELECTRIC HAND BRAKE MANAGEMENT" procedure, then start the "MAINTENANCE MODE" procedure.
NOTE:
Removal process similar for both sides of the vehicle.
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the tire and wheel assembly. Refer to REMOVAL AND INSTALLATION
.
- Disconnect the electrical harness connector (1) to the electric parking brake gear motor.
- Remove and DISCARD
the mounting bolts (2a) and remove the electric parking brake caliper (2b).
- Remove the pin retaining split pins (1).
- Remove the pins (2a), the spring (2b) and the pads (2c) from the caliper body.
- Remove and DISCARD
the mounting bolts (1a) and remove the gear motor (1b).
- Remove and DISCARD the O-ring from the parking brake caliper body.
