With Sunroof: Installation
NOTE:
In the event the headliner is damaged or creased during installation, it will need to be replaced with a new headliner.
Use clean gloves or make sure your hands are clean before removing the headliner.
- With the help of an assistant, position the headliner into the vehicle and hold it into place.
- Connect the wire harness connector to the sunroof motor harness.
- Connect the wire harness connectors at the front headliner speakers.
- Connect the wire harness connector to the rearview mirror.
- Fasten the hook and loop fasteners around the sunroof openings.
- Connect the wire harness connector on the rear shelf.
- Fasten the door seals (1a) at all four door openings, where they meet the headliner.
- Install the two supports (1a) into headliner engaging the inner retainer (1b). Then install the covers.
- Install the grab handles. Refer to HANDLE, GRAB, REMOVAL AND INSTALLATION .
- Install the C-pillar trim panels. Refer to PANEL, C-PILLAR TRIM, REMOVAL AND INSTALLATION Refer to, PANEL, C-PILLAR TRIM, LOWER, REMOVAL AND INSTALLATION .
- Install the upper B-pillar trim panels. Refer to PANEL, B-PILLAR TRIM, UPPER, REMOVAL AND INSTALLATION .
- Install the overhead console. Refer to CONSOLE, OVERHEAD, REMOVAL AND INSTALLATION .
- Install the visors and supports. Refer to VISOR, REMOVAL AND INSTALLATION .
- Install the A-pillar trim panels. Refer to PANEL, A-PILLAR TRIM, REMOVAL AND INSTALLATION .
- Install the rear shelf panel. Refer to PANEL, REAR SHELF, REMOVAL AND INSTALLATION .
- Install the floor console. Refer to CONSOLE, FLOOR, REMOVAL AND INSTALLATION .
- Install the front seats. Refer to SEAT, FRONT, REMOVAL AND INSTALLATION .
- Install the right front door. Refer to DOOR, REMOVAL AND INSTALLATION .
- Connect the negative battery cable.
