Removal And Installation: Base: Removal
WARNING:
Disable the airbag system before attempting any front seat diagnosis or service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.
- Before proceeding with the following repair procedure, review all warnings and cautions. Refer to SEATS, FIRST ROW, WARNING .
- Remove the front seat back panel. Refer to PANEL, SEAT BACK, FRONT, REMOVAL AND INSTALLATION .
- Remove the front seat back. Refer to SEAT BACK, FRONT, REMOVAL AND INSTALLATION Refer to, SEAT BACK, REAR, REMOVAL AND INSTALLATION .
- Remove the headrest sleeves. Refer to SLEEVE, HEADREST, REMOVAL AND INSTALLATION .
- Separate the retainer strip (1a and 1b).
- Release the J-hooks (2a, and 3a).
- Release the pulls (4a).
- Remove the seat back cover (5a) and the seat back foam as an assembly, from the seat frame.
- Open the straps (1a and 1b).
- Working around the perimeter of the cushion, loosen the cover (2) from the seat foam (1c).
- Fold the seat cover (1b) as shown in illustration, and cut the hog rings (1a).
