LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Alfa Romeo >> 2019 >> Giulia Base, AWD >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Body - Interior & Exterior >> Hood >> Cable, Hood Release >> Removal And Installation >> Primary Hood Release Cable >> Removal

Primary Hood Release Cable: Removal

NOTE:

Take note of the cable routing for correct installation.

GC0198502Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery terminal.
  2. Remove the right  hood latch. Refer to LATCH, HOOD, REMOVAL AND INSTALLATION .
  3. Remove the left front wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION .
  4. Remove the cowl cover panel. Refer to COVER, COWL PANEL, REMOVAL AND INSTALLATION .
  5. Remove the push fasteners (1a) and the cover (2a), that covers the left hood latch.
    GC0197867Courtesy of CHRYSLER GROUP, LLC
  6. Working on the left side, disconnect the wire harness connector (1a).
  7. Release the cable retainer (2a), then remove the cable end (2b).
    GC0198380Courtesy of CHRYSLER GROUP, LLC
  8. Remove the cowl side trim panel. Refer to PANEL, COWL TRIM, REMOVAL AND INSTALLATION .
  9. Release the cable retainer (1a), then remove the cable end (1b) from the hood release control (2).
    GC0198121Courtesy of CHRYSLER GROUP, LLC
  10. Unclip the hood release cables (1a) from the body (1b and 1c).
  11. Remove the nuts (2a).
  12. Lift the cable assembly and remove the cable grommet (3b) from the body.
  13. Remove the hood latch release cable from the vehicle.
scientia non olet · About LEMON Manuals