Removal And Installation: Removal

Courtesy of CHRYSLER GROUP, LLC

1. Remove the rear wheelhouse splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL AND INSTALLATION .
2. Remove the fuel filler door. Refer to DOOR, FUEL FILL, REMOVAL AND INSTALLATION  Refer to, DOOR, FUEL FILL LOCK, REMOVAL AND INSTALLATION .
3. Using a flat head screwdriver, press the area with your fingertips (1a) and release the inside body retainers (1b), then remove the housing (1d).
4. Disconnect the wire harness connector (2a) for the fuel door latch (2b).
5. Turn the latch (2b) counter-clockwise and remove it from its seat.

   Courtesy of CHRYSLER GROUP, LLC

6. Working on the left side of the interior, apply a string to the end (1a) of the fuel filler door release cable (1b) (the string will be used to install the cable).

   Courtesy of CHRYSLER GROUP, LLC

7. Working on the rear left side of the wheelhouse, release the cable (1b) feed through grommet (1a) that opens the fuel tank door opening control.
8. Completely remove the cable (1b) from the car, leaving the initially applied probe in its place.
9. Recover the fuel door latch (3a), together with its cable (1b) and feed - through grommet (1a).

Courtesy of CHRYSLER GROUP, LLC

INSTALLATION

1. Fit the cable (1a) in position up to the luggage compartment, using the string left during removal. Remove the sensor.
2. Seat the grommets (2a) in their housings.

   Courtesy of CHRYSLER GROUP, LLC

3. Place the latch (1a) in the coupling gasket (1b) and turn it in its housing.
4. Connect the wire harness connector (2a) of the latch (1a).
5. Position the insert gasket (1b) in place and engage the four inner retainers (3a).

   Courtesy of CHRYSLER GROUP, LLC

6. Check that the cable (1a) is working correctly.
7. Install the fuel filler door. Refer to DOOR, FUEL FILL, REMOVAL AND INSTALLATION  Refer to, DOOR, FUEL FILL LOCK, REMOVAL AND INSTALLATION .
8. Install the rear wheelhouse splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL AND INSTALLATION .