Removal - Front

Courtesy of CHRYSLER GROUP, LLC

1. Apply a double layer of adhesive tape around the edges (1a) around the badge (1b).
   NOTE:

   The purpose of the adhesive tape will be to protect the edge (1a) when the badge is removed.

2. Remove the badge (1b) by releasing the locating pins (2a) and the adhesive (2b) bonding it to the surface (2c), using a trim stick or equivalent.
   NOTE:

   If necessary, gently heat the badge and the surrounding panel using an air heater to make it easier to detach the adhesive.

Courtesy of CHRYSLER GROUP, LLC

INSTALLATION - FRONT

1. Remove the adhesive tape (1a) used for protection from the edge.
2. Remove all adhesive residues and carefully clean and degrease with heptane the area (2a) involved in bonding of the badge.
3. Remove the protective film for the adhesive surface (3a) of the new badge (3b), then immediately position the badge on the zone (2a) engaging the locators (3c); stick the adhesive surface, pressing manually on the badge.
   NOTE:

   Do not touch the adhesive surface (3a) by hand during fitting.