Removal - Side
- Apply a double layer of adhesive tape (1a) around the entire perimeter of the nameplate (1b).NOTE:
The purpose of the adhesive tape will be to protect the body when the nameplate is removed.
- Remove the nameplate (1b) by releasing the locating pins (2a) and the adhesive (2b) bonding it to the surface (2c), using the trim tool.NOTE:
If necessary, gently heat the nameplate and the surrounding metal using an air heater to make it easier to release the adhesive.
NOTE:
If ambient temperatures are below 21° C (70° F), warm the badges and body panel with a heat lamp or gun to assure proper adhesion.
INSTALLATION
- Remove the adhesive tape (1a) used for protection.
- Remove all glue residues and carefully clean and degrease with heptane the area (2a) involved in adhering of the nameplate.
- Remove the protective film for the adhesive surface (3a) of the new nameplate (3b), then immediately position the nameplate on the zone (2a) engaging the locators (3c); stick the adhesive surface, pressing manually on the nameplate.NOTE:
Do not touch the adhesive surface of the nameplate during assembly.