Left Or Right Led Control Unit

REMOVAL 

1. Disconnect and isolate the negative battery cable.
2. Remove the necessary front lamp unit. Refer to UNIT, FRONT LAMP, REMOVAL AND INSTALLATION .

   Courtesy of CHRYSLER GROUP, LLC

3. Remove the control unit (1b) fasteners (1a) from the lamp unit.
4. Disconnect the wire harness connector (2a) from the control unit (1b).
5. Remove the control unit from the front lamp unit.

INSTALLATION 

1. Inspect the integrity of the front lamp unit and the wire harness connector.

   Courtesy of CHRYSLER GROUP, LLC

2. Inspect and verify that the seal (1a) for the control unit (1b) is in good condition and clean.
3. Inspect and verify that the seal ring (2) is clean.
4. Position the control unit (1b) on the front lamp unit and connect the wire harness connector (3a).
5. Install and securely tighten the control unit fasteners (4) securing it to the front lamp unit.
6. Install the front lamp unit. Refer to UNIT, FRONT LAMP, REMOVAL AND INSTALLATION .