Removal And Installation - Center Console Media Hub: Installation
NOTE:
Be certain to take the proper precautions to prevent the floor console and instrument panel from receiving cosmetic damage during the following procedures.
- Install the media hub (1a) into the bezel (1b). Be sure the retaining clips (1c) are fully engaged.
- Connect the wire harness connectors (1b).
- Position and insert the media hub bezel (1c) into the floor console until all integral latches (2a) are fully engaged on the inside of the floor console.
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.

