LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2002 >> Crown Victoria Base, 4.6 9 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - Removal, Overhaul & Installation) >> Fuel Systems >> Fuel Pump Module >> Removal & Installation

Removal & Installation

WARNING: This page is about a different variant/trim than selected.
  1. Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE . Remove fuel tank. See FUEL TANK .
  2. Disconnect pressure transducer harness connector on top rear corner of fuel tank. Remove any dirt from around fuel pump module flange area. Remove 6 fuel pump module retaining bolts. Remove fuel pump module. Remove and discard fuel pump module gasket. To install, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals