Gauges - Testing & Troubleshooting
- Description
- Test & Calibration Procedures
- ECON Switch Test
- Electrical Compass Unit Connector for Inputs and Outputs
- Electrical Compass Zone Selection and Calibration
- Gauge Control Module Input Test
- Outside Air Temperature Indicator Calibration
- Reminder Systems (MICU and Gauge Control Module) Input Test
- Rewriting the ODO Data and Transferring the Service Reminder System Data to a New Gauge Control Module
- Safety Indicator System (MICU and Gauge Control Module) Input Test
- How To Information
- Gauges Self-Diagnostic Function
- Notes
- Entering the Self-Diagnostic Function With the HDS
- Entering the Self-Diagnostic Function (Manual Method)
- The Indicator Drive Circuit Check
- The Ambient Meter Color Variation Check
- Switch Input Check
- The Beeper Drive Circuit Check
- The LCD Segment Check
- The Gauge Drive Circuit Check
- The Communication Line Check
- Ending the Self-Diagnostic Function
- How to Troubleshoot the Electrical Compass
- Gauges Self-Diagnostic Function
- Circuit Diagram
- Symptom Troubleshooting
- Azimuth (direction) information is not shown on the display
- Compass does not calibrate
- Compass shows wrong direction
- Electrical Compass Symptom Troubleshooting Index
- Fuel gauge indication does not rise
- Outside air temperature indicator does not change
- The fuel gauge indication fluctuates
- No picture is shown on the display
- Self-test has failed (flashing the CAL and NW)
- Component Location Index
- Troubleshooting