Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK EXHAUST SYSTEM FOR LEAKS
1. Check for leaks in the exhaust system.
  Are there any leaks?
  
  Yes
  - Repair the leaks as necessary and restore correct operation.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Go To 2
CHECK CONNECTION FOR THE O2 SENSOR 1/2 AND THE PCM-1
1. Check for loose, damaged or corroded connections on the O2 Sensor 1/2 or the PCM-1.
  Are there any loose or corroded connections?
  
  Yes
  - Repair the wiring connections as necessary.
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
  No
  - Go To 3
CHECK PCM-1 AND O2 SENSOR 1/2 WIRING
1. Check the wiring for an open circuit or high resistance between the O2 Sensor 1/2 and (K904) of the connector on vehicle side of the PCM-1.
  Is there a high resistance or open condition in the wiring?
  
  Yes
  - Repair the open circuit or high resistance in the wiring.
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
  No
  - Go To 4
CHECK PCM-1 AND O2 SENSOR 1/2 WIRING
1. Check for a short circuit in the wiring between the O2 Sensor 1/2 and (K904) of the connector on vehicle side of the PCM-1.
  Is there a short circuit in the wiring?
  
  Yes
  - Repair the short circuit in the wiring.
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
  No
  - Go To 5
CHECK O2 SENSOR 1/2 OPERATION
1. Check that the O2 Sensor 1/2 is working properly.
  Is the O2 Sensor 1/2 operation incorrect?
  
  Yes
  - Replace the O2 Sensor 1/2.
  No
  - End of diagnosis.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .