Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

ENGINE OIL LEVEL AND TEMPERATURE SENSOR AND THE CHECK POWERTRAIN CONTROL MODULE CONNECTION
1. Check for loose, damaged or corroded connections on the engine oil level and temperature sensor or on the slave Powertrain Control Module.
  Are there any loose or damaged connections?
  
  Yes
  - Repair the wiring connections as necessary.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Go to 2.
WIRING CHECK ON THE ENGINE OIL LEVEL AND TEMPERATURE SENSOR AND THE POWERTRAIN CONTROL MODULE
1. Check the wiring for an open circuit or high resistance between the engine oil level and temperature sensor and PIN 35 of the connector on engine side of the slave powertrain control module.
  Is there a high resistance or open condition in the wiring?
  
  Yes
  - Repair the open circuit or high resistance in the wiring.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Go to 3.
WIRING CHECK ON THE ENGINE OIL LEVEL AND TEMPERATURE SENSOR AND THE POWERTRAIN CONTROL MODULE
1. Check the wiring for a short circuit between the engine oil level and temperature sensor and PIN 35 of the connector on engine side of the slave powertrain control module.
  Is there a short circuit in the wiring?
  
  Yes
  - Repair the short circuit in the wiring.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Go to 4.
CHECK ENGINE OIL LEVEL AND TEMPERATURE SENSOR OPERATION
1. Check that the engine oil level and temperature sensor is working properly.
  The engine oil level and temperature sensor is not working properly
  
  Yes
  - End of diagnosis.
  No
  - Replace the engine oil level and temperature sensor.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .