Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, read PCM DTCs.
  Is the DTC active or pending?
  
  Yes
  - Go To 3
  No
  - Go To 2
VERIFY IF THE CONDITION IS STILL PRESENT
1. With the scan tool, erase PCM DTCs.
2. Turn the ignition on.
  Did the DTC return?
  
  Yes
  - Go To 3
  No
  - Test Complete.
CHECK THE VEHICLE MODULES FOR ANY MISMATCHED MODULES
1. With the scan tool, check that the topology matches the original build sales codes and that the VIN is correct in each module.
  Are the topology and VIN numbers correct?
  
  Yes
  - Go To 4
  No
  - Replace the module or modules that do not match. With the scan tool, navigate to the Body Control Module (BCM) / Miscellaneous Functions, and perform the "PROXI Configuration Alignment" routine.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
PERFORM A VEHICLE PROXI/CONFIGURATION
1. With the scan tool, navigate to the Body Control Module (BCM) / Miscellaneous Functions, and perform the "PROXI Configuration Alignment" routine.
2. With the scan tool, erase PCM DTCs.
3. Turn the ignition on.
  Did the DTC return?
  
  Yes
  - Go To 5
  No
  - Repair is complete.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
CHECK RELATED PCM AND COMPONENT CONNECTIONS
1. Perform any Service Bulletins that apply.
2. Disconnect all PCM-2 harness connectors.
3. Disconnect all related in-line harness connections (if equipped).
4. Disconnect the related component harness connectors.
5. Inspect harness connectors, component connectors, and all male and female terminals for the following conditions:
  - Proper connector installation.
  - Damaged connector locks.
  - Corrosion.
  - Other signs of water intrusion.
  - Weather seal damage (if equipped).
  - Bent terminals.
  - Overheating due to a poor connection (terminal may be discolored due to excessive current draw).
  - Terminals that have been pushed back into the connector cavity.
  - Check for spread terminals and verify proper terminal tension.
  Repair any conditions that are found.
6. Reconnect all PCM-2 harness connectors. Be certain that all harness connectors are fully seated and the connector locks are fully engaged.
7. Reconnect all in-line harness connectors (if equipped). Be certain that all connectors are fully seated and the connector locks are fully engaged.
8. Reconnect all related component harness connectors. Be certain that all connectors are fully seated and the connector locks are fully engaged.
9. With the scan tool, erase DTCs.
10. Test drive or operate the vehicle in accordance with the when monitored and set conditions.
11. With the scan tool, read DTCs.
  Did the DTC return?
  
  Yes
  - Replace and program the Powertrain Control Module 2 (PCM-2) in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL (PCM), REMOVAL AND INSTALLATION .
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  - Test complete.